The Perfect Server - CentOS 6.1 x86_64 With Apache2 [ISPConfig 3]

Want to support HowtoForge? Become a subscriber!
 
Submitted by falko (Contact Author) (Forums) on Tue, 2011-12-20 18:07. :: CentOS | ISPConfig | Web Server | Apache | Control Panels

The Perfect Server - CentOS 6.1 x86_64 With Apache2 [ISPConfig 3]

Version 1.0
Author: Falko Timme <ft [at] falkotimme [dot] com>
Follow me on Twitter
Last edited 12/18/2011

This tutorial shows how to prepare a CentOS 6.1 x86_64 server for the installation of ISPConfig 3, and how to install ISPConfig 3. ISPConfig 3 is a webhosting control panel that allows you to configure the following services through a web browser: Apache web server, Postfix mail server, MySQL, BIND nameserver, PureFTPd, SpamAssassin, ClamAV, Mailman, and many more. Since version 3.0.4, ISPConfig comes with full support for the nginx web server in addition to Apache; this tutorial covers the setup of a server that uses Apache, not nginx.

Please note that this setup does not work for ISPConfig 2! It is valid for ISPConfig 3 only!

I do not issue any guarantee that this will work for you!

 

1 Requirements

To install such a system you will need the following:

 

2 Preliminary Note

In this tutorial I use the hostname server1.example.com with the IP address 192.168.0.100 and the gateway 192.168.0.1. These settings might differ for you, so you have to replace them where appropriate.

 

3 Install The Base System

Boot from your first CentOS 6.1 DVD (DVD 1). Select Install or upgrade an existing system:

It can take a long time to test the installation media so we skip this test here:

The welcome screen of the CentOS installer appears. Click on Next:

Choose your language next:

Select your keyboard layout:

I assume that you use a locally attached hard drive, so you should select Basic Storage Devices here:

You might see the following warning - Error processing drive. If you see this click on the Re-initialize all button to proceed:

Fill in the hostname of the server (e.g. server1.example.com), then click on the Configure Network button:

Go to the Wired tab, select the network interface (probably eth0) and click on Edit...:

Mark the Connect automatically checkbox and go to the IPv4 Settings tab and select Manual in the Method drop-down menu. Fill in one, two, or three nameservers (separated by comma) in the DNS servers field (e.g. 8.8.8.8,8.8.4.4), then click on the Add button next to the Addresses area:

Now give your network card a static IP address and netmask (in this tutorial I'm using the IP address 192.168.0.100 and netmask 255.255.255.0 for demonstration purposes; if you are not sure about the right values, http://www.subnetmask.info might help you). Also fill in your gateway (e.g. 192.168.0.1) and click on the Apply... button:

The network configuration is now finished. Click on the Next button:


Please do not use the comment function to ask for help! If you need help, please use our forum.
Comments will be published after administrator approval.