Your system is not supported by certbot-auto anymore.

Discussion in 'General' started by claro123, Dec 3, 2020.

  1. claro123

    claro123 New Member

    Code:
    HTTP request sent, awaiting response... 200 OK
    Length: 78564 (77K) [application/octet-stream]
    Saving to: ‘certbot-auto.9’
    
    certbot-auto.9           100%[==================================>]  76.72K  --.-KB/s    in 0.008s
    
    2020-12-03 00:51:53 (9.59 MB/s) - ‘certbot-auto.9’ saved [78564/78564]
    
    [email protected]:/usr/local/bin# chmod a+x certbot-auto
    [email protected]:/usr/local/bin# ./certbot-auto --install-onl
    Skipping bootstrap because certbot-auto is deprecated on this system.
    Your system is not supported by certbot-auto anymore.
    Certbot cannot be installed.
    Please visit https://certbot.eff.org/ to check for other alternatives.
    [email protected]:/usr/local/bin#
     
  2. claro123

    claro123 New Member

    I am trying to install Let's Encrypt on debian 10 but I get this error some solution
     
  3. ahrasis

    ahrasis Well-Known Member HowtoForge Supporter

    I think Neilpang acme.sh will be installed by ISPConfig if you don't have cerbot installed, so basically it should handle all LE SSL certs when certbot is not found, but I am not very sure because I haven't tested it personally.
     
  4. michelangelo

    michelangelo New Member

    Firstly, you've executed the wrong cerbot-auto installer file. The certbot which you've downloaded was saved as certbot-auto.9 and not cerbot-auto unless you forgot to mention that you moved/renamed that file prior execution. If after executing the correct cerbot-auto the installer should still throw the same warning message then follow ahrasis's advice and use acme.sh instead of certbot. acme.sh support should exist, I think since some late ISPConfig 3.1.x version and is definitely supported by the latest ISPConfig release.
     
    Last edited: Dec 3, 2020
    claro123 and Th0m like this.

Share This Page