What is the best structure for multiserver config

Discussion in 'Installation/Configuration' started by Lepic, Nov 28, 2016.

  1. Lepic

    Lepic New Member HowtoForge Supporter

    Hi 2 all, I'm new at ispconfig.
    I need to build multiserver platform with separate mail and hosting.
    I want to have one master server and few slave servers.
    I have one hardware server - dom0, and few virtual servers - xen1, xen2, xen3.
    The question is where to install master server?
    1. I can install master server on dom0, all other VM's will be slave servers.
    or
    2. I can install master server on xen1, mail server will be xen2, hosting server will be xen3
    or
    3. I can install master server and mail server on xen1, hosting server will be xen2, xen3 is not used.
    Which way is better?
     
  2. till

    till Super Moderator Staff Member ISPConfig Developer

    1) I won't install master on dom0, better install it inside a vm.
    2 + 3) are both ok. If you plan to get a big setup with many servers over the time, then use 2 and 2 is more secure than 3.
     
  3. Lepic

    Lepic New Member HowtoForge Supporter

    Thanks a lot, till, for advice!
    What is tha main difference between 1) and 2)?
    I mean, when xen1 is just master control panel, empty from any other services; and when xen1 is master, but handle some of slave services, such as email. Is 2) more secure than 3) in single-hardware config?
    I have bought manual for the team support. Hope I can post another questions here while setup and get support, thanks again.
     

Share This Page