Turn Your $60 Router Into A $600 Router

Discussion in 'Suggest HOWTO' started by MHammer, Aug 31, 2006.

  1. MHammer

    MHammer New Member

    Click Here

    Its a good article that teaches you how to increase your speed and bandwidth. Check it out.
  2. sjau

    sjau Local Meanie Moderator

    That's a nice article. Thanks for posting it.
  3. falko

    falko Super Moderator ISPConfig Developer

    I've already tried this on a WRT54G. It's nice that this model runs a Linux and allows you to install different firmware. :)
  4. 3cwired_com

    3cwired_com New Member

    I have this installed on my router as of this past week, and I am happy so far, and I haven't even touched any of the features.
    Last edited: Jun 26, 2007
  5. beatty_t

    beatty_t New Member


    Thanks a lot for posting this article. It has actually saved me a bit of time at work. We had a pc about 35 ft away from a WRT54G, but blocked by 2 walls and the connection speed was "low/non-existant". I was just going to send a cat5 cable through the ceiling, but now we get a "good/very good" connection (FYI: I up-ed the signal strength to 95mW and the router is noticeably warmer... I'll probably lower it to 70mW as recommended in the article and hope that the signal strength doesn't suffer too much). I'm gonna do the same to my router at home!


Share This Page