Setting up Getty for my serial console remote server

Discussion in 'Installation/Configuration' started by Appie Thrasher, Jun 5, 2010.

  1. Appie Thrasher

    Appie Thrasher Member HowtoForge Supporter


    Finally i have put my server in a DC. but I run into some troubles.

    At home I was able to view the boot proces trough the serial console and could change everything with my keyboard over putty.

    If I now log in to my serial console (server in DC) I dont see the boot proces.

    The support told me to install getty. I found this tutorial.

    But my qustion will this work with my ISPC3 perfect set-up? Because the fist command mentioned already does not work.
    [email protected]:~# dmesg | grep tty
    I know my serial port ttyS0 so its no problem but I ask just to be sure not to mess things up.
  2. till

    till Super Moderator Staff Member ISPConfig Developer

    I've not tried this tutorial, but I dent see any conflicts with the perfect setup guide.
  3. Appie Thrasher

    Appie Thrasher Member HowtoForge Supporter

    Thanks Till

Share This Page