Set up Network Problem

Discussion in 'Server Operation' started by Ridd1ck, Nov 11, 2011.

  1. Ridd1ck

    Ridd1ck New Member

    I have Fedora 15 and when i try to use this command:
    route add default gw 192.168.1.254 eth0
    i get this error:
    SIOCDELRT: No such process
    Can you help me?
     
  2. falko

    falko Super Moderator ISPConfig Developer

  3. Ridd1ck

    Ridd1ck New Member

    eth0 Link encap:Ethernet HWaddr 50:E5:49:40:3B:96
    inet addr:79.***** Bcast:79.***** Mask:255.255.255.0
    inet6 addr: fe80::::fe40:3b96/64 Scope:Link
    UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
    RX packets:29885391 errors:0 dropped:3403682 overruns:0 frame:0
    TX packets:273528 errors:0 dropped:0 overruns:0 carrier:0
    collisions:0 txqueuelen:1000
    RX bytes:3410517956 (3.1 GiB) TX bytes:43766711 (41.7 MiB)
    Interrupt:52 Base address:0xc000

    p21p1 Link encap:Ethernet
    HWaddr 00:1F:1F:E9:9E:2F
    inet addr:192.168.1.1 Bcast:192.168.1.255 Mask:255.255.255.0
    inet6 addr: fe80::21f:1fff:fee9:9e2f/64 Scope:Link
    UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
    RX packets:8418487 errors:0 dropped:0 overruns:0 frame:0
    TX packets:14821646 errors:0 dropped:0 overruns:0 carrier:0
    collisions:0 txqueuelen:1000
    RX bytes:1444570033 (1.3 GiB) TX bytes:1981938726 (1.8 GiB)
    Interrupt:53 Base address:0x6000

    This is the output and i want to configure two subinterface , one p21p1:1 and the other eth0:1 with ip address in the same subnet as the primary interface.
    When i create files in network script this can't work.
     
    Last edited: Nov 15, 2011
  4. falko

    falko Super Moderator ISPConfig Developer

    How did you manage to have one device with the old naming scheme (eth0) and one device with the new namig scheme? :confused:
     

Share This Page