rspamd clamd question

Discussion in 'Installation/Configuration' started by Steffan, Oct 16, 2019.

  1. Steffan

    Steffan Member

    with amavisd clamd was running.
    Does rspamd also needs clamd?
    After the switch to rspamd i see a high cpu load from clamd

    if i look at the yum log
    Sep 11 09:53:53 Installed: rspamd-1.9.4-2.x86_64
    Sep 11 15:01:41 Erased: clamav-0.101.4-1.el7.x86_64
    Sep 11 15:03:16 Installed: clamav-0.101.4-1.el7.x86_64

    Also i see Spamassassin daemon running.
    im a little bit lost what rspamd needs and what can be removed savely
    any ideas?
     
  2. till

    till Super Moderator Staff Member ISPConfig Developer

    clamd is used by rspamd in the same way amavis is using ist. amavisd should not be started after you switched to rspamd.
     
  3. Steffan

    Steffan Member

    oke thanxs that explaines a lot, and Spamassassin?
     
  4. till

    till Super Moderator Staff Member ISPConfig Developer

    spamasssain daemon needs not to be started, neither with amavis nor rspamd.
     
  5. Tuhin

    Tuhin New Member

    How can I remove clamd and keep rspamd please ?
     
  6. elmacus

    elmacus Member HowtoForge Supporter

    You need clamd for antivirus, its not built in rspamd.
     
  7. Tuhin

    Tuhin New Member

    Yeah I know but I have to disable clamd as it consume too much memory. I disabled clamd when I was using amavis but later amavis replaced with rspamd and clamd activated again!
     
  8. till

    till Super Moderator Staff Member ISPConfig Developer

    Try to stop clamd, if mail still works, uninstall clamd. I have not tried that yet so you have to check what happens.
     
  9. Tuhin

    Tuhin New Member

    Thanks!
    It's worked! It's simpler than amavis!
     
  10. recin

    recin Member

    Isn't amavis required for DKIM?
     
  11. elmacus

    elmacus Member HowtoForge Supporter

    No.
     
  12. Tuhin

    Tuhin New Member

    If you replace amavis with rspamd, then rspamd is going to use the same key under /etc/amavis/dkim/
    You don't need amavis to be activated for that.

    But if you don't use neither amavis or rspamd, you are going to miss DKIM.
     

Share This Page