Removing ALL of XSane

Discussion in 'Installation/Configuration' started by measekite, Jan 4, 2011.

  1. measekite

    measekite New Member

    I removed what I thought was all of XSane using Synaptic. However there still must have been some file left over. Upon installation and doing everything I was supposed to do my Epson 4180 is still not recognized by XSane after reinstall.

    It was working fine under Mav 10.10 for quite some time until I installed TurboPrint. Apparently the install did something. Still I initially was able to run it by:

    Code:
    sudo xsane
    but even after changing the 50 rules file from 0664 to 0666 it did not work. So I did a complete removal via Synaptic and a complete install but now it will not even work under root.

    Any ideas.
     
  2. falko

    falko Super Moderator Howtoforge Staff Moderator HowtoForge Supporter ISPConfig Developer

    Any errors in your logs?
     

Share This Page