Real IP configuration

Discussion in 'Installation/Configuration' started by anastasia0181, May 14, 2009.

  1. anastasia0181

    anastasia0181 New Member

    Hi every,
    I am trying to install a didicated server with ISPConfig2 to host my personnel site. I installed Centos4.7 following the steps in the link http://www.howtoforge.org/perfect-server-centos-4.7, now i need to install the ISPCongif2, but going through the installation manual , I did not find anything about the Real IP that my domains will point to, my question is my IP that i got from my ISP provider 64.32.xxx.xxx i configured it on the router,will this be enough to acess my sites anywhere or i need to change some configuration files on my server.
    Thank you for your help,
     
  2. falko

    falko Super Moderator

    What's the output of
    Code:
    ifconfig
    ?
     
  3. anastasia0181

    anastasia0181 New Member

    Thank you FALKO for your reply, I really appreciate your help.
    Here is the result of ifconfig:

    eth0 Link encap:Ethernet HWaddr 00:0D:56:94:AE:A2
    inet adr:192.168.112.41 Bcast:192.168.112.255 Masque:255.255.255.0
    adr inet6: fe80::20d:56ff:fe94:aea2/64 Scope:Lien
    UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
    RX packets:123988 errors:0 dropped:0 overruns:0 frame:0
    TX packets:34150 errors:0 dropped:0 overruns:0 carrier:0
    collisions:0 lg file transmission:100
    RX bytes:9652740 (9.2 MiB) TX bytes:5393155 (5.1 MiB)

    lo Link encap:Boucle locale
    inet adr:127.0.0.1 Masque:255.0.0.0
    adr inet6: ::1/128 Scope:Hôte
    UP LOOPBACK RUNNING MTU:16436 Metric:1
    RX packets:1572 errors:0 dropped:0 overruns:0 frame:0
    TX packets:1572 errors:0 dropped:0 overruns:0 carrier:0
    collisions:0 lg file transmission:0
    RX bytes:2457368 (2.3 MiB) TX bytes:2457368 (2.3 MiB)


    I installed the ISPConfig2 but at the last step after configuring the ssl, i was asked to enter my host and domain, but it gives me error the url is not reachable,i did some research and some posts as a solution is to configure the domain in /etc/hosts, my /etc/hosts looks like this:
    [root@serv ~]# cat /etc/hosts
    # Do not remove the following line, or various programs
    # that require network functionality will fail.
    127.0.0.1 localhost.localdomain localhost
    192.168.112.41 serv.mysite.com serv

    Can you please tell me how to configure my domain in this file, thank you in advance.
     
  4. anastasia0181

    anastasia0181 New Member

    Dear Falko,
    I finished the installation of ISPconfig successfully by leaving the host name: empty and i put the server local ip as the domain.
     

Share This Page