Question two eths

Discussion in 'General' started by pontifex, Aug 22, 2006.

  1. pontifex

    pontifex New Member

    Hi everyone,

    one question. does ipsconfig support two networkinterfaces? eth0, eth1??

    Our Server is connected to the switch using eth0 and eht1

  2. pablito

    pablito New Member

    I'm pretty sure that you can. I only use 1 NIC but I have 3 IPs plus a VPN channel (eth0, eth0:1, tun0, etc.). In the configs where appropriate I specify the IP(s) I want to use. Works as expected.
  3. falko

    falko Super Moderator ISPConfig Developer

    Yes. Configure both NICs and then add the IP addresses to Management -> Server -> Settings (if they aren't already listed there).

Share This Page