Discussion in 'HOWTO-Related Questions' started by hardeep, May 31, 2006.

  1. hardeep

    hardeep New Member

    i get the following message on logging in on xen3.0!

    -bash: no job control in this shell
    [email protected]:~$

    what is that suppose to mean and how can i get rid of it.

    the link to the howto is:

  2. hardeep

    hardeep New Member

    also while booting domU i get the following error message:

    8250: no version for "struct_module" found: kernel tainted.
    8250: Unknown symbol uart_get_baud_rate
    8250: Unknown symbol uart_resume_port
    8250: Unknown symbol uart_register_driver
    8250: Unknown symbol uart_suspend_port
    8250: Unknown symbol uart_remove_one_port
    8250: Unknown symbol uart_update_timeout
    8250: Unknown symbol uart_unregister_driver
    8250: Unknown symbol uart_get_divisor
    8250: Unknown symbol uart_match_port
    8250: Unknown symbol uart_add_one_port
    8250: Unknown symbol uart_write_wakeup
    modprobe: FATAL: Error inserting 8250 (/lib/modules/2.6.16-xen/kernel/drivers/serial/8250.ko): Unknown symbol in module, or unknown parameter (see dmesg)

    any clues to whats going on...??
  3. falko

    falko Super Moderator ISPConfig Developer

    How many VMs do you have running at the same time? More than four?

    Do you use some proprietary drivers?
  4. hardeep

    hardeep New Member

    hi falko,

    well its not a loop problem, i have only 2 VMs running anyway. however, I still can not figure out why there is the problem. i guess there is some mismatch between the kernel and the driver version.

    i was doing a bit of searching and found these ready to boot images on:

    and they seem to run perfect! so i guess as of now i have a vm running perfectly. however, am still curious to find out the reason for the error. would be educating.

  5. falko

    falko Super Moderator ISPConfig Developer

    I guess it has something to do with some proprietary driver. You know, kernel developers don't like proprietary drivers. :(

Share This Page