Hi all, please excuse this basic question. (below runs on Centos5, no gui) I'm using zoneminder with IP cameras, and found they put an immense strain on the local network (192.168.1.x). I rigged up a secondary router (10.0.1.x) for the cameras, and installed a second NIC on my camera server. My intention was to have the server "bridge" the connections via a route. The only way i was able to gain connectivity from computers on the 192 side was this: In the second NIC setup, i had to enter 192.168.1.1 as the gateway (as opposed to 10.0.1.1, which is what my secondary router lives as). What I found was that I had successfully reduced the load on my primary network, but ZM performance was extremely slow. Here's my question: With my setup, is all traffic still routing from the 10.0.1.x network, through the 192.168.1.1 router, and then to zoneminder? Is there a better way I can set this up? I like the idea of having the cameras on their own router for troubleshooting and security purposes. And again, please excuse my rudimentary question. Thanks in advance.