loop-aes in etch

Discussion in 'Installation/Configuration' started by hotchilli, Jul 3, 2007.

  1. hotchilli

    hotchilli New Member

    loop-aes now comes with the installer in etch.

    however I can get only to the point below cannot seem to create the
    / mount point for root or home?

    1 primary 501.7mb F ext3 /boot
    2 primary 1.4gb K crypto not active
    3 primary 9.0gb K crypto not active
    pri/log FREE SPACE 2gb

    in the case of the root partition 1.4gb I did set the mount / as root
    same for home 9.0 gb but it comes up as not active?


    any suggestions would be welcome

    hotchilli
     
  2. hotchilli

    hotchilli New Member

    report a bug

    apprently this is a bug in etch installer ???????????/
     
  3. falko

    falko Super Moderator ISPConfig Developer

Share This Page