Lets Encrypt Configuration

Discussion in 'Installation/Configuration' started by Eliezer Ga, Jul 21, 2021.

  1. Eliezer Ga

    Eliezer Ga New Member

    Hi All,
    I hope you can help me I have a ispconfig 3.2.5 server and I upgraded the version of certbot using this link https://certbot.eff.org/ I follow the instructions and was able to install it, however when I generate an SSL to ispconfig GUI (under webserver) it is not working anymore. I need to activate it using ssh and when I run certbot -v command. Please see the image below:

    upload_2021-7-21_20-58-5.png

    What do I need to do to make the SSL creation working in ispconfig GUI:
    upload_2021-7-21_20-59-28.png
    Thank you for your support
     
  2. ahrasis

    ahrasis Well-Known Member HowtoForge Supporter

    1. You just need to tick Let's Encrypt SSL box and wait until the LE certs are issued.

    2. You shouldn't go to SSL tab thereafter at all, so what you did by going there and create SSL certs in there is totally wrong, if you did do that.

    3. To fix this, if you did do that, you should delete that SSL certs totally, even if it means you have to go and delete them manually too. Then just do #1.

    4. If that #1 failed, do read sticky thread on LE FAQ in here.
     

Share This Page