Ispconfig 3 master dns - Plesk slave dns

Discussion in 'Installation/Configuration' started by mixian, Jun 23, 2010.

  1. mixian

    mixian New Member

    i have setup a DNS server with ispconfig 3, and i have another server with plesk.

    I want to make ispconfig masterr DNS and Plesk as slave server.

    It's possible now with MyDns & Bind ?

    What tricks to ISPConfig in configuration file of MyDns to send data to slave?

    If not possible, exist a professional service for slave dns ustomizable with my domain name ( ?!??!?!

    Thanks to all.
  2. Mark_NL

    Mark_NL New Member

  3. till

    till Super Moderator Staff Member ISPConfig Developer

    You can use bind with ispconfig as well since ispconfig 3.0.2. The installation instructions for bind on ispconfig systems can be found in the docs folder of the ispconfig tar.gz file.
  4. mixian

    mixian New Member

    Thank to all.

    But...Till, i have look this

    where you say : mydns is not a dns-resolver...install dnsmasq....

    The result is the same:

    dig -t any

    ; <<>> DiG 9.3.2-P2.1 <<>> -t any
    ; (1 server found)
    ;; global options: printcmd
    ;; Got answer:
    ;; ->>HEADER<<- opcode: QUERY, status: SERVFAIL, id: 11683
    ;; flags: qr aa rd ra; QUERY: 1, ANSWER: 0, AUTHORITY: 0, ADDITIONAL: 0

    ; IN ANY

    ;; Query time: 28 msec
    ;; SERVER:
    ;; WHEN: Wed Jun 23 17:41:35 2010
    ;; MSG SIZE rcvd: 27

    Also command ... i have cancelled "-t any"....but my authority .it fail the nameserver


    ; <<>> DiG 9.7.0-P1 <<>>
    ; (1 server found)
    ;; global options: +cmd
    ;; Got answer:
    ;; ->>HEADER<<- opcode: QUERY, status: NOERROR, id: 56137
    ;; flags: qr aa rd ra; QUERY: 1, ANSWER: 1, AUTHORITY: 1, ADDITIONAL: 1

    ; IN A

    ;; ANSWER SECTION: 86400 IN A



    ;; Query time: 2 msec
    ;; SERVER:
    ;; WHEN: Wed Jun 23 16:26:50 2010
    ;; MSG SIZE rcvd: 84
    Last edited: Jun 23, 2010
  5. till

    till Super Moderator Staff Member ISPConfig Developer

    But thats not related to the topic you asked here. If your server is a resolver for non local queries or not ahs no influence on the fact if it shall be the master for a plesk dns server.

    If you want to query the local server, the the query is:

    dig @localhost

    and if you do not get an answer, then you have no dns zone for on that server. In that case, check the dns records that you created. many popele miss the dots at the end of all fully quoalified domain records. To prevent that, use the dns wizard to create zones!

Share This Page