ipsconfig3 on Lenny how-to troubles | myDNS

Discussion in 'Installation/Configuration' started by tomdavidson, Nov 7, 2009.

  1. tomdavidson

    tomdavidson New Member

    hi, i followed this how-to and ran in to a few hang ups:
    http://www.howtoforge.com/perfect-server-debian-lenny-ispconfig3

    1) There is no /etc/init.d/openbsd-inetd to restart. I do not know the impact of this.

    2) MyDNS does not start with /etc/init.d/mydns start.
    • It does not produce an error, but after running /etc/init.d/mydns start and than looking at netstat, there is no mydns.
    • I can start mydns via /usr/local/sbin/ ./mydns but have some errors

    Does mydns need additional config not described in the tutorial?

    File: /etc/init.d/mydns
    File: /etc/mydns.conf
     
    Last edited: Nov 7, 2009
  2. till

    till Super Moderator Howtoforge Staff HowtoForge Supporter ISPConfig Developer

    Plesae proceed with the setup. ISPConfig will reconfigure mydns while you run the ispconfig installer.
     
  3. tomdavidson

    tomdavidson New Member

    Hi Till, thanks for the reply:
    I did complete the process. It was not until seeing the monitor warning in the ISPConfig3 interface that I realized myDNS has a problem.

    Perhaps the installer did not configure myDNS on my install?

    -tom
     
  4. snowch

    snowch New Member

    I had the error about /etc/init.d/openbsd-inetd too installing on Debian 5.0 too.

    I assumed that it's no problem because we didn't need any inetd services anyway.

    Is it worth making a note in the install doc that if there is an error when starting openbsd-inetd, ignore it?

    Many thanks,

    Chris
     

Share This Page