IPCop Config Question

Discussion in 'Installation/Configuration' started by nuukem, Sep 13, 2007.

  1. nuukem

    nuukem New Member

    I currently have an IPCop firewall in front of my web server at a co-lo. The co-lo assigned me an initial bank of IP's which are currently configured within IPCop. If I navigate to Status --> Network Status in the menu, I can see all 15 IP's listed as eth1:0, eth1:1, eth1:2, etc. I was just assigned an additional bank of IP's but these new IP's have a different gateway than the initial ones. I did go to Network --> Aliases and add each of the new IP's there, but when I try to ping any of those new ones, I don't get a response (I have ECHO request enabled within IPCop).

    Here is an example of the IP's...

    Block A: - - Gateway

    Block B: - - Gateway

    How would I configure IPCop with these 15 new IP's and the second gateway?

    Thanks for any help,

  2. nuukem

    nuukem New Member

    Anyone have any ideas?
  3. falko

    falko Super Moderator ISPConfig Developer

    Unfortunately not... :(

Share This Page