installing domu on linux dom0 using CentOS-5.3-i386-bin-DVD.iso

Discussion in 'Installation/Configuration' started by laksh, Oct 26, 2009.

  1. laksh

    laksh New Member


    need help in installing domU on linux dom0 using CentOS-5.3-i386-bin-DVD.iso
  2. falko

    falko Super Moderator ISPConfig Developer

  3. laksh

    laksh New Member

    installing domU from CentOS-5.3-i386-bin-DVD.iso

    thanks for the reply
    please help me installing domU from CentOS-5.3-i386-bin-DVD.iso. my config file looks like below.

    kernel= "/xen/xen-3.4.1/dist/install/boot/vmlinuz-"
    memory = 128
    name = "mailserver"
    vif = [ 'mac=00:16:3e:00:00:11,bridge=xenbr0' ]
    root = "/dev/sda1 ro xencons=tty"
    disk = ['file:/lakxen/suselinux/xenimg/CentOS-5.3-i386-bin-DVD.iso,hda:cdrom,r', 'file:/lakxen/suselinux/image/disk.img,sda1,w', ]

    but when i run the config file using xm create -c vm1.cfg I got the following error.

    i8042.c: No controller found.
    mice: PS/2 mouse device common for all mice
    TCP bic registered
    NET: Registered protocol family 1
    NET: Registered protocol family 17
    Using IPI No-Shortcut mode
    xen-vbd: registered block device major 3
    blkfront: hda: barriers enabled
    hda: unknown partition table
    xen-vbd: registered block device major 8
    blkfront: sda1: barriers enabled
    XENBUS: Device with no driver: device/console/0
    kjournald starting. Commit interval 5 seconds
    EXT3-fs: mounted filesystem with ordered data mode.
  4. matey

    matey New Member

    is the file system you are trying to bring up still mounted (by any chance)?

    Also does the system read into ISO files without any problems?

Share This Page