Heartbeat issue when rebooting one node

Discussion in 'Installation/Configuration' started by gregory, Dec 16, 2008.

  1. gregory

    gregory New Member

    Hello everyone,

    I've a strange problem. I have installed hearbeat and IPVS according the HOWTO's found on howtoforge.com.
    Everything is working well. I have tested the HA solution, I stopped heartbeat on one node and see that the second is taking well the resources.
    But when I restart one node, the second don't take the resources and my website is down.

    When I checked the status heartbeat is stopped on the 2 nodes. I need to start manually one heartbeat on one node.

    For me everything seems to be OK, I see on the first node :
    master running
    (ipvs_syncmaster pid: 4683)

    and on the second node:
    master stopped
    (ipvs_syncbackup pid: 15617)

    I have noticed also that if the first node is running (the master) and I rebooted the second one. The "ipvs_syncbackup pid" is not displayed.
    I must do a heartbeat restart to have this line.

    Could you give some advices to investigate this issue?

    Thanks a lot,

  2. falko

    falko Super Moderator ISPConfig Developer

    So when you restart heartbeat, it just stops, but doesn't start again? Did you check your syslog?
  3. gregory

    gregory New Member

    Correct entries are found in my syslog.
    But now it's working. I think I don't have enough patience. When I stop the heartbeat manually, the other takes the resources very fast. But when I reboot one node, the other takes the resources correctly but it seems to do it more slower.

    Maybe I can review my settings to speed up.

    Thanks a lot for the support.


Share This Page