FC5 Postfix Source RPM Problems in HOW-TO

Discussion in 'HOWTO-Related Questions' started by nsurge, Sep 13, 2006.

  1. nsurge

    nsurge New Member

    Hi,
    I'm using the http://www.howtoforge.com/fedora_virtual_postfix_mysql_quota_courier
    for Fedora Core 5. I keep getting errors when I try to rebuild the new RPM.

    Here is the error:
    ...
    /usr/bin/ld: cannot find -lmysqlclient
    collect2: ld returned 1 exit status
    make: *** [master] Error 1
    make: *** [update] Error 1
    error: Bad exit status from /var/tmp/rpm-tmp.94646 (%build)
    ...

    Any ideas on this? I've followed the how-to exactly, plus had to install a few extra packages.

    I tried to follow the link below to the authors RPM, but it gave me an "not authorized" error.
    http://www.howtoforge.com/downloads...ysql_quota_courier/postfix-2.2.8-1.2.i386.rpm

    I get:

    wget http://www.howtoforge.com/downloads...ysql_quota_courier/postfix-2.2.8-1.2.i386.rpm
    --17:40:52-- http://www.howtoforge.com/downloads...ysql_quota_courier/postfix-2.2.8-1.2.i386.rpm
    => `postfix-2.2.8-1.2.i386.rpm'
    Resolving www.howtoforge.com... 85.10.207.148
    Connecting to www.howtoforge.com|85.10.207.148|:80... connected.
    HTTP request sent, awaiting response... 403 Forbidden
    17:40:53 ERROR 403: Forbidden.


    This is on a new Dell 1850, 64bit FC5.

    Thanks for any input, mostly why that link is erroring out!

    Thanks,
    Nathan
     
  2. nsurge

    nsurge New Member

    Fixed - Almost

    I've fixed most my problems, I basically reloaded my FC5 install, it was acting up in more ways than one. I made sure to load all the dev libraries too on the intial install. When I went to rebuild the RPM again, that did the trick, everything went smoothly. If anyone needs that built RPM, let me know, I can get a link for it.

    Nathan
     
  3. falko

    falko Super Moderator ISPConfig Developer

Share This Page