External IP and internal IP

Discussion in 'Installation/Configuration' started by qb7, May 21, 2012.

  1. qb7

    qb7 New Member

    I have a problem wich config SSL sites in my ispconfig 3' environment.
    CentOS 5.6, Ispconfig (the last).

    I assigned internal IPs in /etc/sysconfig/network-scripts how to manual, 192.168.0.xxx (LAN IPs) in eth0:1, eth0:2, etc and when assigned external IP (WAN IP) 80.28.xxx.xxx, in eth0:10, eth0:11 for SSL, don't work the internet access and the server is down.

    How I have to set the internet IPs in eth0:x for SSL web sites?

    I set external IP in eth0:XX because Falko wrote in a post wich IPs for SSL must be in the comand ifconfig.
    Last edited: May 21, 2012
  2. till

    till Super Moderator Staff Member ISPConfig Developer

    You mix up internal and external IP's here. On your server you configure only the internal IP addresses and not the external ones and then choose the internal IP address in the website setings of the SSL site.
  3. qb7

    qb7 New Member

    But when I made the SSL certificate in the control panel, them I have to select the internet IP (external IP)?
    Last edited: May 21, 2012
  4. till

    till Super Moderator Staff Member ISPConfig Developer

    Yes, you have to select the internal IP. In a NAT enviroment, the internal IP is used for apache as the translation between internal and external Ip is done on the router.

Share This Page