doveadm replicator status

Discussion in 'Installation/Configuration' started by LotNoMore, Apr 14, 2017.

  1. LotNoMore

    LotNoMore Member

    My master/slave Ubuntu 16.10 apache server pair setup went OK after some problems in the begging.
    Unison install and sync went OK too.
    The only thing that does not seem to be right is the email syncing with Dovecot. I followed the instruction given in the PDF manual carefully, but when I run this command on both servers:
    doveadm replicator status '*'
    I got this without any response content:
    What could be wrong?
    Instructions in the PDF manual says to add a huge block of content in /etc/dovecot/dovecot.conf but I notice that it already has some content in it, like ....
    I simply added the suggestion portion to the very top - so that combined content is like this...
    is this right?
    Last edited: Apr 14, 2017
  2. florian030

    florian030 ISPConfig Developer ISPConfig Developer

    do not add this on top of the config. add it to the existing config and do not define services / plugins twice. Did you open port 4711 in the firewalls?
  3. LotNoMore

    LotNoMore Member

    I wondered that when I did it. Then where should I add it that to?
    As for the firewalls on both the master and slave servers, I use this command:

Share This Page