Debian squeeze update errors

Discussion in 'Installation/Configuration' started by rdan, Jan 29, 2012.

  1. rdan

    rdan Member HowtoForge Supporter

    I have an update problem on squeeze with Ispconfig 3. Error is as follows:
    Setting up nfs-common (1:1.2.2-4squeeze2) ...
    insserv: warning: script 'K01jailkit' missing LSB tags and overrides
    insserv: Service portmap has to be enabled to start service nfs-common
    insserv: exiting now!
    update-rc.d: error: insserv rejected the script header
    dpkg: error processing nfs-common (--configure):
    subprocess installed post-installation script returned error exit status 1
    configured to not write apport reports
    Errors were encountered while processing:
    nfs-common

    I have attempted to run update and safe-upgrade with portmap enabled but the error still appears. Any advice? Thanks.
     
  2. falko

    falko Super Moderator ISPConfig Developer

    Run
    Code:
    insserv portmap
    and try again.
     
  3. rdan

    rdan Member HowtoForge Supporter

    Thank Falco. I ran insserv portmap and then ran aptitude update and aptitude safe-upgrade. After innserv portmap the response was as follows:

    insserv: warning: script 'K01jailkit' missing LSB tags and overrides
    insserv: warning: script 'jailkit' missing LSB tags and overrides

    after running aptitude update and aptitude safe-upgrade the response was as follows:

    aptitude safe-upgrade
    The following partially installed packages will be configured:
    nfs-common
    No packages will be installed, upgraded, or removed.
    0 packages upgraded, 0 newly installed, 0 to remove and 0 not upgraded.
    Need to get 0 B of archives. After unpacking 0 B will be used.
    Setting up nfs-common (1:1.2.2-4squeeze2) ...
    insserv: warning: script 'K01jailkit' missing LSB tags and overrides
    insserv: warning: script 'jailkit' missing LSB tags and overrides
    Stopping NFS common utilities: statd.
    Starting NFS common utilities: statd failed!

    I re-ran the update and safe-upgrade procedure and there were no errors. Neither portmap nor nfs-common are running right now. It looks like your code did the trick. Thanks again.
    Rick
     

Share This Page