Connecting to ispconfig.org ... failed:

Discussion in 'Installation/Configuration' started by Richard506, Jan 12, 2013.

  1. Richard506

    Richard506 New Member

  2. falko

    falko Super Moderator

    No problem here. Maybe a routing problem of your provider?
     
  3. Richard506

    Richard506 New Member

    Thank you Falko. But that is not the reason for the problem. I did the install of everything else without editing /etc/network/interfaces at the beginning.
    Then just before I did the above I filled in what I thought were the IP addresses for
    /etc/network/interfaces and then the screw up.
    Obviously, my numbers were wrong. So could you please tell me which numbers to use?
    Thank you

    The Connection Information from my AT & T router are as follows:
    I did not include the IPv6 information.

    Internet IPv4 Address 108.196.2.1.196
    Internet Gateway IP Address 108.195.3.354

    Local Network
    Gateway IPv4 Address 192.168.1.254

    IP Information
    Primary DNS Address 99.99.99.53
    Secondary DNS Address .

    IP Interface
    IP Address 192.168.1.254 Netmask 255.255.255.0 Name eth0

    Network Routing Table
    Destination 192.168.1.0 Netmask 255.255.255.0 Gateway 0.0.0.0
    Destination 192.168.3.0 Netmask 255.255.255.0 Gateway 0.0.0.0

    Host Routing Table
    Destination 127.0.0.1 Netmask 255.255.255.255 Gateway 192.168.1.254 br0
    Destination 108.195.3.254 Netmask 255.255.255.255 Gateway 0.0.0.0 ppp0

    LAN Information
    Gateway IPv4 Address 192.168.1.254
    Gateway Netmask 255.255.255.0

    Devices on LAN
    IP Address 192.168.1.244 MAC Address xxxxx Name RB(me) Status Active
    IP Address 192.168.1.84 MAC Address xxxx Name bmc-server(ubuntu) Active

    After the above problem, I reinstalled the entire thing without touching /etc/network/interfaces and everything including the ISPConfig3 downloaded and installed OK.

    So please tell me the right numbers to use.

    Thanks in advance
     
    Last edited: Jan 13, 2013
  4. falko

    falko Super Moderator

    Try this:

    Code:
    # This file describes the network interfaces available on your system
    # and how to activate them. For more information, see interfaces(5).
    
    # The loopback network interface
    auto lo
    iface lo inet loopback
    
    # The primary network interface
    auto eth0
    iface eth0 inet static
            address 192.168.1.100
            netmask 255.255.255.0
            network 192.168.1.0
            broadcast 192.168.1.255
            gateway 192.168.1.254
            dns-nameservers 8.8.8.8 8.8.4.4
     

Share This Page