Configure network settings and eth cards

Discussion in 'Installation/Configuration' started by Txchaser, Mar 16, 2008.

  1. Txchaser

    Txchaser New Member

    I am needing help in cofiguring my eth cards to connect to the internet. I have tried for days and with various settings with no luck. I am installing opensuse and am using zone edit for dynamic DNS. if anyone would mind helping please let me kow.
     
  2. falko

    falko Super Moderator ISPConfig Developer

    Is the SUSE system behind a router? If so, what's the router's internal IP address?
    What's the output of
    Code:
    ifconfig
    on the SUSE system?
     
  3. Txchaser

    Txchaser New Member

    output of ifconfig

    eth0
    Link encap:Ethernet HWaddr 00:--:--: ect.
    inet addr: 192.168.1.105 Bcast: 192.168.1.255 Mask: 255.255.255.0
    inet6 addr: fe80::290:27ff:ffec:7459/64 Scope: Link
    UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
    Rx packets:27743 errors:0 dropped:0 overruns:0 frame:0
    TX packets:4453 errors:0 dropped:0 overruns:0 carrier:0
    collisions:0 txqueuelen:1000
    RX bytes:1839773 (1.7Mb) TX bytes:207632 (202.7 Kb)

    lo
    Link encap: Local Loopback
    inet addr: 127.0.0.1 Mask: 255.0.0.0
    inet6 addr: ::1/128 Scope:Host
    UP LOOPBACK RUNNING MTU:16436 Metric:1
    Rx packets:0 errors:0 dropped:0 overruns:0 frame:0
    Tx packets:0 errors:0 dropped:0 overruns:0 carrier:0
    collisions:0 txqueuelen:0
    Rx bytes:0 (0.0 b) Tx bytes:0 (0.0b)
     
  4. falko

    falko Super Moderator ISPConfig Developer

    What's the router's internal IP address? What's the output of
    Code:
    route -nee
    ?
     

Share This Page