Clamv Segmentation Fault when I moved VDH

Discussion in 'Installation/Configuration' started by necdettenekeci, Sep 14, 2012.

  1. necdettenekeci

    necdettenekeci New Member


    I exported the virtual machine from Hyper-V and imported in other host machine. I needed to set eth5 to eth6. Everything works well but clamav.

    When I try to start clam-daemon it gives an error saying Segmentation Fault.

    I uninstalled clamav and installed again. Problem is the same.

    I tried to reconfigure clamav not to scan mails, but problem continued.

    What can I do?

    EDIT: VDH on the subject is VHD

    Last edited: Sep 14, 2012
  2. necdettenekeci

    necdettenekeci New Member

    At least can I export mailqueue to old server without internet connection from new server. Because now old server is running and I have no other IP addresses.

Share This Page