Change password on Squirrelmail under ISPConfig

Discussion in 'Installation/Configuration' started by soho, Jun 2, 2007.

  1. soho

    soho Member

    I installed the ISPConfig in the CentOS, following the tutorial of the Falko (http://www.howtoforge.com/perfect_setup_centos5.0). I installed after the package squirrelmail.pkg. I installed the translation of the squirrelmail for my language (pt_BR) and now wanted to install one plugin of the squirrelmail so that the proper user of the email changed its password. I found this plugin (http://squirrelmail.org/plugin_view.php?id=117) that it interacts with /etc/passwd or /etc/shadow.

    Somebody already tested this plugin and knows if it functions or it could indicate me another way to make this?

    Thanks in advance.

    Sergio
     
  2. till

    till Super Moderator Staff Member ISPConfig Developer

    I recommend to not use this plugin, use the ISPConfig mail user login instead.
     
  3. soho

    soho Member

    hi till,


    I thank its reply, but using mailuser the user has that to insert the credentials in the format to web5_user and not in the similar format user@domain.com to the squirrelmail.

    In mailuser exists some configuration that I will be able to make so that the user inserts user@domain.com as in the squirrelmail?

    Sorry for my bad English...:D

    Sergio
     
  4. till

    till Super Moderator Staff Member ISPConfig Developer

    No, thats not correct. The mailuser login of ISPConfig is in the format user@domain.com and not web5_user.
     
  5. soho

    soho Member

    hummmm... then I made some thing missed in the configurations, therefore I did not obtain to have access with the format user@domain.com, presents the error “unknow user”.

    I go to check my configurations and to try to find the problem.

    Sergio
     
  6. soho

    soho Member

    Hi Til,

    I tried to find some error in the configurations, but so far I did not find. I create the Customer, after that the site, I configure everything, I create the email account (user@domain.com), access the webmail and to send messages. But if to try to have access mailuser, with the format user@domain.com always is shown the error of "Unknown User".

    With the format to web5_user access without problems.

    Some tip?
     
  7. soho

    soho Member

    hummmm... Now I was confused: in this post (http://www.howtoforge.com/forums/showthread.php?t=9627&page=4&highlight=mailuser) is mentioned that the mailuser login with username and not email-address.

     
  8. the_spy

    the_spy New Member

    there is an other post in the forum which say how to have email address login with squirrelmail with some changes
     
  9. soho

    soho Member

    I thank the_spy, but the question now is not the squirrelmail, now the problem is to mailuser. The solution that necessary is a simple and practical tool where the users can change its password of email without the intervention of the ISP support.
     

Share This Page