Centos 6.2 - a problem building courier with rpmbuild

Discussion in 'HOWTO-Related Questions' started by dimas, Apr 23, 2012.

  1. dimas

    dimas Member

    Please kindly help me with a problem.

    I'm now following the Perfect Server guide for Centos 6.2 with Apache. Now I'm stuck on page 4:


    The problem is - I can't build courier's rpm:

    sudo rpmbuild -ta courier-authlib-0.63.0.tar.bz2

    I get (after some processing) this error:

    Segmentation fault

    and then shortly afterwards the process stops with:
    Bad exit status from ...

    SeLinux is disabled, and otherwise the setup is followed strictly (except for the partitioning scheme, because I use software raid 1)

    I don't know if it's pertinent, but I see the following messages during the boot-time, while loading udev

    Failed to enable MSI-X

    and also:
    ACPI: I/O resource 0000:00:1f.3 [0xf040-0xf05f] conflicts with ACPI region SMBI [0xf040-0xf04f]

    but udev starts with a green OK nonetheless

    but later it says something like "catching up udev unfinished tasks" - and it also gives a green OK.

    So, I wonder,

    1. What could be the possible reason of my failing to rpmbuild courier-authlib?

    2. Are the boot-time messages I've described above critical for a production system?
  2. falko

    falko Super Moderator ISPConfig Developer

    It's almost impossible to say why you get a segfault. There can be millions of reasons, for example a hardware failure...

Share This Page