can not access my ispconfig page from outside network

Discussion in 'Installation/Configuration' started by wake2010, Sep 10, 2011.

  1. wake2010

    wake2010 New Member

    hey all, once again i have ran into another problem.

    I decided to go for a new host name,
    i set it up with and the default page works when i type in the hostname on port 80, however when i try it with 8080 it just sits and loads all day, the title changes with ISPConfig but so far nothing else. I uninstalled ISPconfig and reinstalled it but so far not working...

    any ideas??


    if you need the host name let me know and ill PM it.
  2. mentes

    mentes Member

    I think your are at home or at office connected to internet through a router.

    Did you open 8080 port?
  3. wake2010

    wake2010 New Member

    i have set the server as a DMZ and set all packets to go to the server IP ( at present i can not test anything as I have a new project and as such the ISPConfig project is on hold, I will when i get the chance to re run the system give you an update but at present all i get is port 80 when i type in the FQDN, when i try FQDN:8080 it just sits on loading using both IE and Firefox, ports are fully open using s port scanner we have at work, the server is at home on a fast cable connection. But as i say i can not do much as i have had to pull that server out and do this new project.... Damn good GUI though :)
  4. falko

    falko Super Moderator ISPConfig Developer

    Can you check Apache's error log?

    Also, can you check all your vhosts (especially the ISPConfig vhost) if they use the correct IP?

Share This Page