Beryl Blues

Discussion in 'HOWTO-Related Questions' started by cheeesemonger, Oct 9, 2007.

  1. cheeesemonger

    cheeesemonger New Member

    I have a R420 vid card from ATI, and I've been trying to get Beryl working. I used this tutorial, and it worked beautifully! But I reinstalled for unrelated reasons, and now, when I go to install Beryl again, I get to
    and instead I get:
    And now I'm very confused. For context, here is my xorg.conf:
    and the output of glxinfo:
    Thanks for helping!
     
  2. cheeesemonger

    cheeesemonger New Member

    breakthrough(?)

    OOH! this looks important.
    returns
     
  3. cheeesemonger

    cheeesemonger New Member

    ...

    I tried blacklisting the output of
    but to no avail. The crusade rages on!
     
  4. falko

    falko Super Moderator Howtoforge Staff Moderator HowtoForge Supporter ISPConfig Developer

    Maybe a problem with the ATI driver. Have you tried to reboot the system?
     
  5. cheeesemonger

    cheeesemonger New Member

    bewildered, but happy.

    I rebooted, and there was no change. but then I powered down all the way, and all the way back up. Now I have DRI, so maybe the BIOS wasn't reloading properly on a soft reboot. I'm not going to tempt fate by delving deeper. Thanks!
     
  6. cheeesemonger

    cheeesemonger New Member

    hopefully...

    with luck, my changes worked, and they just needed a full reboot. :D
     

Share This Page