Adding php-mbstring after full LAMP and ispconfig install.

Discussion in 'Installation/Configuration' started by Buzzen, Mar 18, 2007.

  1. Buzzen

    Buzzen New Member

    How can I add the php-mbstring module to apache2 after the installation is complete?

    Normally I would just remove apache2 and compile it again with php-mbstring but since this system is live I am hoping I have another option.

    Any ideas?
  2. till

    till Super Moderator Staff Member ISPConfig Developer

    Thta depends on how you installed your system. If you followed one of the perfect setup guides, you will just have to install zthe php-mbstring package from your linux distribution. With all modern linux distributions it is not nescessary anymore to recompile apache or php (if a common module is missing) as they are all compiled with module support.
  3. Buzzen

    Buzzen New Member

    Thanks Till, I wasnt aware that the process was so simple nowadays. :p

Share This Page