Segmentation fualt error during compile

[Con Hennekens]

That's pitifully not the case... I was testing on a old compaq Deskpro 400Mhz/512MB. I still have a 333Mhz board laying around somewhere. Maybe I'll give that a shot today or tomorrow. If the error Magically disappears I give it notice here.

Con

[lerra]

I solved my problem! Tested with compule a kernel, worked. ln'd it so /usr/src/linux pointed to it (bercause system compilation needs system headers sometimes...) did not work, rebooted and did a full diskscan and then runned again and it worked. I installed gcc-3.4 too but dont think it was that one that solved it.

I'm running debian sarge 3.1

[lerra]

Seams like found the error...I get some page fault error when i try to install from a ssh client but not local (using a uml to test the installation) thrue the console.
Working on a sollution.

[falko]

You get errors when you try to install ISPConfig over SSH, but locally it works?

[lerra]

seams like I solved my critical problem by incresing the RAM to the uml, only had 64 at the begining and increesed to 96 (not running a swap ether)

[lerra]

Originally Posted by falko

You get errors when you try to install ISPConfig over SSH, but locally it works?

Yes, coud be just me..

[Con Hennekens]

The error in case here (see beginning of thread) is a compile error. Hard to believe that it could have something to do with SSH. In my case it it also happened during a local session. Ram also is no issue, I have 512MB in my box.

[falko]

Originally Posted by Con Hennekens

The error in case here (see beginning of thread) is a compile error. Hard to believe that it could have something to do with SSH. In my case it it also happened during a local session. Ram also is no issue, I have 512MB in my box.

Have you tried Memtest? http://www.howtoforge.com/forums/sho...48&postcount=6