Installing a 2nd NIC

[warlock]

Hi All,

I have installed a second nic card into my server it is running ubuntu 8.10 and ispconfig 2.x,

When I enabled the the second card, we are unable to connect to the server via http or smtp. I have not changed any config files yet ?

Just to add, I have install VMware Server and ISPConfig 3.x on a VM, I am wanting to use the 2nd nic on the VM, curerntly my router forwards all ISPConfig traffic to NIC1, I have "or will give" NIC2 an IP which I can slowly migrate domain to the new ISPCONFIG server and direct the traffic to that IP.

[falko]

What are the outputs of

ifconfig

and

route -nee

?

[warlock]

IFci

eth0      Link encap:Ethernet  HWaddr 00:15:17:60:c8:b0
          inet addr:192.168.1.250  Bcast:192.168.1.255  Mask:255.255.255.0
          inet6 addr: fe80::215:17ff:fe60:c8b0/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:1053 errors:0 dropped:0 overruns:0 frame:0
          TX packets:950 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:100
          RX bytes:109181 (109.1 KB)  TX bytes:193280 (193.2 KB)
          Memory:b8820000-b8840000

eth0:0    Link encap:Ethernet  HWaddr 00:15:17:60:c8:b0
          inet addr:192.213.164.26  Bcast:192.213.164.255  Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          Memory:b8820000-b8840000

eth1      Link encap:Ethernet  HWaddr 00:15:17:60:c8:b1
          inet addr:196.21x.16x.2x  Bcast:19x.21x.16x.31  Mask:255.255.255.248
          inet6 addr: fe80::215:17ff:fe60:c8b1/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:9969 errors:0 dropped:0 overruns:0 frame:0
          TX packets:7625 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:100
          RX bytes:13197974 (13.1 MB)  TX bytes:559917 (559.9 KB)
          Memory:b8800000-b8820000

lo        Link encap:Local Loopback
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:1737 errors:0 dropped:0 overruns:0 frame:0
          TX packets:1737 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:450088 (450.0 KB)  TX bytes:450088 (450.0 KB)

vmnet1    Link encap:Ethernet  HWaddr 00:50:56:c0:00:01
          inet addr:172.16.210.1  Bcast:172.16.210.255  Mask:255.255.255.0
          inet6 addr: fe80::250:56ff:fec0:1/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:25 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:0 (0.0 B)  TX bytes:0 (0.0 B)

vmnet8    Link encap:Ethernet  HWaddr 00:50:56:c0:00:08
          inet addr:172.16.220.1  Bcast:172.16.220.255  Mask:255.255.255.0
          inet6 addr: fe80::250:56ff:fec0:8/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:24 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:0 (0.0 B)  TX bytes:0 (0.0 B)

route -nee

Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface    MSS   Window irtt
196.21x.16x.24  0.0.0.0         255.255.255.248 U     0      0        0 eth1     0     0      0
192.213.164.0   0.0.0.0         255.255.255.0   U     0      0        0 eth0     0     0      0
172.16.210.0    0.0.0.0         255.255.255.0   U     0      0        0 vmnet1   0     0      0
192.168.1.0     0.0.0.0         255.255.255.0   U     0      0        0 eth0     0     0      0
172.16.220.0    0.0.0.0         255.255.255.0   U     0      0        0 vmnet8   0     0      0
0.0.0.0         196.21x.16x.25  0.0.0.0         UG    100    0        0 eth1     0     0      0
0.0.0.0         192.168.1.1     0.0.0.0         UG    100    0        0 eth0     0     0      0

[warlock]

Just a little more explination

The server1 has 2 nic's

It is sitting behind router2 which is plugged into router1 which is connected to a thrid internet router with 5 ip's

Internet router IP x.x.x.25 (LAN SIDE)
Router1 - WAN x.x.x.27 & LAN 10.10.0.1
Router2 - WAN 10.10.0.2 & LAN 192.168.1.1
eth0 192.168.1.250

I want to migrate to ISPConfig3 on a VM on the server1
I want to setup eth1 with IP x.x.x.26 so that it's internet facing and then I can slowly change DNS to point to the new IP as I mirgate the domains and sites.

Another options is to use apache and somehow mail routing. but this I don't know how to do either.
The VM ca use eth0 or eth1 for traffic. so which ever is easier as this is temp till the migration is complete.

[Franz]

you have 2 default gateways...

[warlock]

I understands this but how do I configure it that if traffic comes in on eth0 it should also got out on eth0 and the same for eth1 ?

[vestport]

I would also like to know the answer to this question. I am having a similar problem with 2 NIC's. In my case though it appears only the LAN gateway shows and not a the real WAN gateway IP.

Art