can't access ispconfig interface

[dimas]

I've just installed ispconfig on suse 10.0 (following the perfect setup). There were no errors during the installation of either linux or ispconfig. However, when I try to access ispconfig interface from a different pc (both pcs are on the same local network) I get 'the page cannot be displayed' error.

I haven't set up a domain yet, so in the course of ispconfig installation I just left the 'host name' field empty and put '192.168.2.136' (that's the ip of the pc where ispconfig is installed) in the 'domain' field.

But when I type (I chose https protocol) https://192.168.2.136:81/ I get the above-mentioned error.

At the same time if I just type http://192.168.2.136 the apache page comes up, so apache is running ok.

Any help or hints will be highly appreciated.

By the way, maybe the problem is that my pc at the moment has only one static ip?

[dimas]

I'm beginning to think that the problem is in the https protocol.

Can I change the ispconfig access protocol from https to http without re-installing ispconfig?

[till]

Please try to access the page with the firefox browser, it has better error messages then IE.

[dimas]

Thank you for your advice, indeed firefox has better error messages.

Well, the error message says (I'm translating it from Russian):

"It's impossible to establish a protected connection, because the certificate provided by 192.168.2.136 is either invalid or damaged. Error code -8182"

What can be done about this?

[till]

Please have a look here:

http://www.howtoforge.com/forums/showthread.php?t=121

[dimas]

Thanks a lot for your help! It works!