ClamAV doesn't work - fresh installation Version: 2.2.1

[tom]

I've installed ISPconfig on an fresh Debian Sarge xen host. UebiMiau Webmail was directly installed with the ISP installer.

Everything works fine but ClamAV doesn't work. I've no Idea why?

The maiheader shows that:

X-Virus-Status: Failed
X-Virus-Report: /home/admispconfig/ispconfig/tools/clamav/bin/clamscan error 153
X-Virus-Checker-Version: clamassassin 1.2.3 with clamscan / ClamAV 0.88.1/1398/Fri Apr 14 11:03:44 2006
X-UM-Flags: \SEEN

tom

[tom]

When I try to start clamd with:

/home/admispconfig/ispconfig/tools/clamav/sbin/clamd

I get this:

ERROR: Can't get information about user adm42go.

What about the user adm42go?

tom

[till]

Please try to change with the su command to a mailuser and then run the command:

/home/admispconfig/ispconfig/tools/clamav/bin/clamscan

Did you get any errors?

[tom]

Originally Posted by till

Please try to change with the su command to a mailuser and then run the command:

/home/admispconfig/ispconfig/tools/clamav/bin/clamscan

Did you get any errors?

No errors

tom

[tom]

Originally Posted by tom

No errors

tom

How are the dependences from clamAV?
Do I need some other .dep packeges maybay?

tom

[falko]

No, ClamAV comes with ISPConfig and is compiled from the sources.
Which ISPConfig version do you use?

[tom]

Originally Posted by falko

No, ClamAV comes with ISPConfig and is compiled from the sources.
Which ISPConfig version do you use?

According to the threadtitle:
fresh installation Version: 2.2.1
:-)

tom

[hastlaug]

I'm not using the new release yet, but maybe you should check the clamassassin script (don't know where it is stored exactly, but I guess you'll find it)

In the upper part of the script there are several pathes to needed programs stored... maybe one of the pathes is wrong? Or maybe one of these programs isn't installed?

My guess: You haven't installed sigtool

[tom]

Originally Posted by hastlaug

I'm not using the new release yet, but maybe you should check the clamassassin script (don't know where it is stored exactly, but I guess you'll find it)

In the upper part of the script there are several pathes to needed programs stored... maybe one of the pathes is wrong? Or maybe one of these programs isn't installed?

My guess: You haven't installed sigtool

I've found sigtool already installed in
/home/admispconfig/ispconfig/tools/clamav/bin/sigtool
and
/home/admispconfig/ispconfig/tools/clamav/bin/clamav-config
the pathes and the programs as well seems to be ok.

tom

[hastlaug]

Okay, I haven't had a look on the new release, so I could only guess. But I don't have further ideas (yet), sorry...