Beyrl and Ubuntu 7.04

[falko]

Originally Posted by Toriacht

segmentation error
core dumped

It seems the Beryl binaries don't work properly on your hardware. You could try to compile Beryl from the sources or from the source .deb packages (maybe easier).

[Toriacht]

Hi Falko,

Thanks for all your replies. I think I'll just leave it for now...I'll wait till a later version of Beryl.

Thanks again,
Toriacht...

[sheds]

I've been following the instructions on the link below to install beryl on ubuntu feisty fawn:

http://www.howtoforge.com/ubuntu_fei...ryl_ati_radeon

It looks fairly simple, but i get stuck not on executing commands, but downloading the GPG key from the link the manual specifies. More in detail, this link:
wget http://ubuntu.beryl-project.org/root@lupine.me.uk.gpg -O- | sudo apt-key add -

I get the following error when executing that line:
Password:--02:27:04-- http://ubuntu.beryl-project.org/root@lupine.me.uk.gpg
=> `-'
Resolving ubuntu.beryl-project.org... 80.77.247.17, 82.140.42.54, 88.191.250.18, ...
Connecting to ubuntu.beryl-project.org|80.77.247.17|:80... connected.
HTTP request sent, awaiting response... 404 Not Found
02:27:04 ERROR 404: Not Found.

From where do i get the key so that i can continue to install beryl?

Thanks in advance for the help.

[falko]

The link's working for me. Maybe you made a typo?

[sheds]

I copied the link as it is, i didn't type it. You don't get that error message i am getting? Weird!!! I swear i just copy the link that's on the manual, and paste it on the shell prompt, and that's what i get.

[falko]

Yes, it's working for me.
Can you try the link in a browser?

[sfxc13]

I used the HowTo guide and everything was working perfectly, until I did something stupid. I was trying to activat the s-video port on my laptop and enabled the ATI accelerated graphics driver in the restriced drivers menu. Now the Beryl icon load, and no errors are displayed, but none of the functions exist. I immediately disabled the ATI driver, but nothing changed. I then completely removed all beryl packages in synaptic package manager and reinstalled following the guide, however I still have the same problem. Any ideas?

[falko]

Originally Posted by sfxc13

I used the HowTo guide and everything was working perfectly, until I did something stupid. I was trying to activat the s-video port on my laptop and enabled the ATI accelerated graphics driver in the restriced drivers menu. Now the Beryl icon load, and no errors are displayed, but none of the functions exist. I immediately disabled the ATI driver, but nothing changed. I then completely removed all beryl packages in synaptic package manager and reinstalled following the guide, however I still have the same problem. Any ideas?

Can you open a new thread for this? Otherwise this one'll get too confusing.