[ISPConfig3] Firewall port range

[peterspoon]

So, I have a short question. How to open some port range in ISPC3? When I input ports like xxx:yyy I get
ERROR
1. tcp_ports_error_regex

Should I use some other syntax? Or is it disabled? I remember it was possible in ISPC2.

[till]

Port ranges are disabled at the moment as the regex for the input test does not allow them. I added : to the regex, so if you upadte to the ltesat svn revision then port ranges should work now.

[millipede]

Hi

I am using ISPC 3.0.1.3
I am trying to open a range for passive FTP
The firewall page does accept the : now as you mentioned (thanks), but it does not open the whole range.
It seems only to open the start port:

e.g. my entry in ISPC
server.name 20,21,22,25,80,110,143,443,8810,20000:30000

and iptables -L shows:

Chain PUB_IN (4 references)
target     prot opt source               destination
ACCEPT     icmp --  anywhere             anywhere            icmp destination-unreachable
ACCEPT     icmp --  anywhere             anywhere            icmp echo-reply
ACCEPT     icmp --  anywhere             anywhere            icmp time-exceeded
ACCEPT     icmp --  anywhere             anywhere            icmp echo-request
PAROLE     tcp  --  anywhere             anywhere            tcp dpt:ftp-data
PAROLE     tcp  --  anywhere             anywhere            tcp dpt:ftp
PAROLE     tcp  --  anywhere             anywhere            tcp dpt:ssh
PAROLE     tcp  --  anywhere             anywhere            tcp dpt:smtp
PAROLE     tcp  --  anywhere             anywhere            tcp dpt:www
PAROLE     tcp  --  anywhere             anywhere            tcp dpt:pop3
PAROLE     tcp  --  anywhere             anywhere            tcp dpt:imap2
PAROLE     tcp  --  anywhere             anywhere            tcp dpt:https
PAROLE     tcp  --  anywhere             anywhere            tcp dpt:8810
PAROLE     tcp  --  anywhere             anywhere            tcp dpt:20000
DROP       icmp --  anywhere             anywhere
DROP       all  --  anywhere             anywhere

whereas our entry in question should read

PAROLE     tcp  --  anywhere             anywhere            tcp dpts:20000:30000

or am I terribly wrong here?

best regards and keep up the good work,
Christian