drbd error -115

[anandx]

Originally Posted by tebokkel

Check if you have CONFIG_HIGHMEM=y in your config. A backup of config is usually saved in /boot or from the running kernel in /proc/config.gz.

Check HighFree in /proc/meminfo, check bootlog for grep highmem..

HTH,

Paul

Looks like its all there

# CONFIG_NOHIGHMEM is not set
CONFIG_HIGHMEM4G=y
# CONFIG_HIGHMEM64G is not set
CONFIG_HIGHMEM=y
CONFIG_DEBUG_HIGHMEM=y

Here are the values for HIGHFREE and HIGHTotal

HighTotal:     1153424 kB
HighFree:       901096 kB

[tebokkel]

Well.. sounds to me that the warnings during RPM-build are the cause for the failures/errors during module load. Do I understand correctly that the compiled sources (without RPM) work correctly?
Than perhaps a header-mismatch somewhere in your distribution is the cause of all your problems.

Paul

[anandx]

Originally Posted by tebokkel

Well.. sounds to me that the warnings during RPM-build are the cause for the failures/errors during module load. Do I understand correctly that the compiled sources (without RPM) work correctly?
Than perhaps a header-mismatch somewhere in your distribution is the cause of all your problems.

Paul

With centos normal kernel, yes them seem to be getting compiled, not with the centosplus kernel. Now since my raid card drivers are in the regular kernel itself, i will try to load both san servers with the same kernel and then try.

[anandx]

Alright i have another problem with this now. Using the standard kernel, i don't get to use the jfs module I need the jfs module to sometimes mount the san volumes locally for testing, which come enabled in plus kernel.

So any reason why the iscsitarget won't compile under centosplus kernel ?

[falko]

I have no idea.

[anandx]

Problem solved. Here is how i resolved it.

Installed the standard kernel, compiled and the iscsitarget module got compiled and installed properly. Then installed the plus kernel and rebooted inside it. Did a make install in the previous compiled version, redid a make, make install, and it worked fine.

Have no idea why the above would work, but it did and now centosplus kernel has the iscsitarget 0.17 version compiled and running properly.