[QUOTE=edge]small note that if you use the ISPconfig Portscanner they always show open!
Category Status Test Name Information
Parent PASS Missing Direct Parent check OK. Your direct parent zone exists, which is good. Some domains (usually third or fourth level domains, such as example.co.us) do not have a direct parent zone ('co.us' in this example), which is legal but can cause confusion.
INFO NS records at parent servers Your NS records at the parent servers are:
ns1.grikservers.com. [91.xxx.xxx.150 (NO GLUE)] [*U]
ns2.grikservers.com. [91.xxx.xxx.150 (NO GLUE)] [*U]
[These were obtained from grdns-us.ics.forth.gr]
PASS Parent nameservers have your nameservers listed OK. When someone uses DNS to look up your domain, the first step (if it doesn't already know about your domain) is to go to the parent servers. If you aren't listed there, you can't be found. But you are listed there.
WARN Glue at parent nameservers WARNING. The parent servers (I checked with grdns-us.ics.forth.gr.) are not providing glue for all your nameservers. This means that they are supplying the NS records (host.example.com), but not supplying the A records (192.0.2.53), which can cause slightly slower connections, and may cause incompatibilities with some non-RFC-compliant programs. This is perfectly acceptable behavior per the RFCs. This will usually occur if your DNS servers are not in the same TLD as your domain (for example, a DNS server of "ns1.example.org" for the domain "example.com"). In this case, you can speed up the connections slightly by having NS records that are in the same TLD as your domain.
PASS DNS servers have A records OK. All your DNS servers either have A records at the zone parent servers, or do not need them (if the DNS servers are on other TLDs). A records are required for your hostnames to ensure that other DNS servers can reach your DNS servers. Note that there will be problems if your DNS servers do not have these same A records.
NS INFO NS records at your nameservers Your NS records at your nameservers are:
ns1.grikservers.com. [91.xxx.xxx.150] [TTL=86400]
FAIL Open DNS servers ERROR: One or more of your nameservers reports that it is an open DNS server. This usually means that anyone in the world can query it for domains it is not authoritative for (it is possible that the DNS server advertises that it does recursive lookups when it does not, but that shouldn't happen). This can cause an excessive load on your DNS server. Also, it is strongly discouraged to have a DNS server be both authoritative for your domain and be recursive (even if it is not open), due to the potential for cache poisoning (with no recursion, there is no cache, and it is impossible to poison it). Also, the bad guys could use your DNS server as part of an attack, by forging their IP address. Problem record(s) are:
Server 91.xxx.xxx.150 reports that it will do recursive lookups. [test] Server 91.xxx.xxx.150 reports that it will do recursive lookups. [test] See this page for info on closing open DNS servers.
PASS Mismatched glue OK. The DNS report did not detect any discrepancies between the glue provided by the parent servers and that provided by your authoritative DNS servers.
PASS No NS A records at nameservers OK. Your nameservers do include corresponding A records when asked for your NS records. This ensures that your DNS servers know the A records corresponding to all your NS records.
PASS All nameservers report identical NS records OK. The NS records at all your nameservers are identical.
PASS All nameservers respond OK. All of your nameservers listed at the parent nameservers responded.
PASS Nameserver name validity OK. All of the NS records that your nameservers report seem valid (no IPs or partial domain names).
FAIL Number of nameservers ERROR: You have 2 nameservers, but both are on the same IP! This is not a valid setup. You are required to have at least 2 nameservers, per RFC 1035 section 2.2.
PASS Lame nameservers OK. All the nameservers listed at the parent servers answer authoritatively for your domain.
FAIL Missing (stealth) nameservers FAIL: You have one or more missing (stealth) nameservers. The following nameserver(s) are listed (at your nameservers) as nameservers for your domain, but are not listed at the parent nameservers (therefore, they may or may not get used, depending on whether your DNS servers return them in the authority section for other requests, per RFC2181 5.4.1). You need to make sure that these stealth nameservers are working; if they are not responding, you may have serious problems! The DNS Report will not query these servers, so you need to be very careful that they are working properly.
This is listed as an ERROR because there are some cases where nasty problems can occur (if the TTLs vary from the NS records at the root servers and the NS records point to your own domain, for example).
FAIL Missing nameservers 2 ERROR: One or more of the nameservers listed at the parent servers are not listed as NS records at your nameservers. The problem NS records are:
PASS No CNAMEs for domain OK. There are no CNAMEs for promos.com. RFC1912 2.4 and RFC2181 10.3 state that there should be no CNAMEs if an NS (or any other) record is present.
PASS No NSs with CNAMEs OK. There are no CNAMEs for your NS records. RFC1912 2.4 and RFC2181 10.3 state that there should be no CNAMEs if an NS (or any other) record is present.
WARN Nameservers on separate class C's WARNING: We cannot test to see if your nameservers are all on the same Class C (technically, /24) range, because the root servers are not sending glue. We plan to add such a test later, but today you will have to manually check to make sure that they are on separate Class C ranges. Your nameservers should be at geographically dispersed locations. You should not have all of your nameservers at the same location. RFC2182 3.1 goes into more detail about secondary nameserver location.
PASS All NS IPs public OK. All of your NS records appear to use public IPs. If there were any private IPs, they would not be reachable, causing DNS delays.
PASS TCP Allowed OK. All your DNS servers allow TCP connections. Although rarely used, TCP connections are occasionally used instead of UDP connections. When firewalls block the TCP DNS connections, it can cause hard-to-diagnose problems.
FAIL Single Point of Failure ERROR: Although you have at least 2 NS records, they both point to the same server, resulting in a single point of failure. You are required to have at least 2 nameservers per RFC 1035 section 2.2.
INFO Nameservers versions Your nameservers have the following versions:
FAIL Stealth NS record leakage Your DNS servers leak stealth information in non-NS requests:
Stealth nameservers are leaked [vasilis13.ath.cx.]!
This can cause some serious problems (especially if there is a TTL discrepancy). If you must have stealth NS records (NS records listed at the authoritative DNS servers, but not the parent DNS servers), you should make sure that your DNS server does not leak the stealth NS records in response to other queries.
SOA INFO SOA record Your SOA record [TTL=86400] is:
Primary nameserver: vasilis13.ath.cx.
Hostmaster E-mail address: admin.promos.com.
Serial #: 2007051704
Default TTL: 86400
PASS NS agriment on SOA serial # OK. All your nameservers agri that your SOA serial number is 2007051704. That means that all your nameservers are using the same data (unless you have different sets of data with the same serial number, which would be very bad)! Note that the DNS Report only checks the NS records listed at the parent servers (not any stealth servers).
WARN SOA MNAME Check WARNING: Your SOA (Start of Authority) record states that your master (primary) name server is: vasilis13.ath.cx.. However, that server is not listed at the parent servers as one of your NS records! This is legal, but you should be sure that you know what you are doing.
PASS SOA RNAME Check OK. Your SOA (Start of Authority) record states that your DNS contact E-mail address is: firstname.lastname@example.org
. (techie note: we have changed the initial '.' to an '@' for display purposes).
PASS SOA Serial Number OK. Your SOA serial number is: 2007051704. This appears to be in the recommended format of YYYYMMDDnn, where 'nn' is the revision. So this indicates that your DNS was last updated on 17 May 2007 (and was revision #4). This number must be incremented every time you make a DNS change.
PASS SOA REFRESH value OK. Your SOA REFRESH interval is : 28800 seconds. This seems normal (about 3600-7200 seconds is good if not using DNS NOTIFY; RFC1912 2.2 recommends a value between 1200 to 43200 seconds (20 minutes to 12 hours)). This value determines how often secondary/slave nameservers check with the master for updates.
PASS SOA RETRY value OK. Your SOA RETRY interval is : 7200 seconds. This seems normal (about 120-7200 seconds is good). The retry value is the amount of time your secondary/slave nameservers will wait to contact the master nameserver again if the last attempt failed.
PASS SOA EXPIRE value OK. Your SOA EXPIRE time: 604800 seconds. This seems normal (about 1209600 to 2419200 seconds (2-4 weeks) is good). RFC1912 suggests 2-4 weeks. This is how long a secondary/slave nameserver will wait before considering its DNS data stale if it can't reach the primary nameserver.
PASS SOA MINIMUM TTL value OK. Your SOA MINIMUM TTL is: 86400 seconds. This seems normal (about 3,600 to 86400 seconds or 1-24 hours is good). RFC2308 suggests a value of 1-3 hours. This value used to determine the default (technically, minimum) TTL (time-to-live) for DNS entries, but now is used for negative caching.