View Single Post
  #1  
Old 20th August 2006, 09:17
BCNW BCNW is offline
Junior Member
 
Join Date: Aug 2006
Posts: 10
Thanks: 0
Thanked 0 Times in 0 Posts
Default Xen 3.0 Setup For Debian newb problem-No network connectivity on first dom0 boot

Hello all, thanks in advance to any help here. Fairly new to linux in general, and I am following the Xen and Debian howto to the letter, and when I boot into dom0 for the first time I lose connectivity. Here is the ifconfig results in regular Debian boot:

eth0 Link encap:Ethernet HWaddr 00:40:F4:EB:C5:15
inet addr:192.168.0.104 Bcast:192.168.0.255 Mask:255.255.255.0
inet6 addr: fe80::240:f4ff:feeb:c515/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:112 errors:0 dropped:0 overruns:0 frame:0
TX packets:52 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:23745 (23.1 KiB) TX bytes:6817 (6.6 KiB)
Interrupt:177 Base address:0xb000

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:8 errors:0 dropped:0 overruns:0 frame:0
TX packets:8 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:560 (560.0 b) TX bytes:560 (560.0 b)

which works fine

and ifconfig under dom0 looks like this:

eth0 Link encap:Ethernet HWaddr 00:40:F4:EB:C5:15
inet addr:192.168.0.104 Bcast:192.168.0.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets: errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes: (0.0 b)
Interrupt:19 Base address:0xe400

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:8 errors:0 dropped:0 overruns:0 frame:0
TX packets:8 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:560 (560.0 b) TX bytes:560 (560.0 b)

Is it because I don't have ipv6 support in dom0? I don't know how it wouldn't have gotten compiled when I did my make install.
Reply With Quote
Sponsored Links