View Single Post
  #3  
Old 28th July 2012, 11:28
NeonNexxus NeonNexxus is offline
Junior Member
 
Join Date: Jun 2012
Posts: 11
Thanks: 0
Thanked 2 Times in 1 Post
Default Thank you for the reply falco.

Maybe you remember my other post about setting xen over Centos6.2
Now i am setting kvm over Suse 12.1 minimal install.
And I have again the public IP addresses for the server.
If you remember I have the server ip xxx.xxx.xxx.xxx and the other 4 ip's the third octect changes and I need to create a bridge nat wont work since all the IP's are public.
So i need to create a bridge which according to your tutorial works but i need to create the dummy0 to use it as the bridge and do not use eth0 as the bridge.
This is of course a different server but needs to be installed same as centos (my other post) but with suse.
My other post was this ..
http://www.howtoforge.com/forums/showthread.php?t=57674
and now i am doing the same but with suse 12.1
Thanks Falco.
Ed.

Last edited by NeonNexxus; 28th July 2012 at 12:27. Reason: Adding
Reply With Quote