my /etc/fstab:
Code:
proc /proc proc defaults 0 0
none /dev/pts devpts rw 0 0
As for your question:
Quote:
|
Do you use OpenVZ? Did you run the commands on the OpenVZ host (not inside the container)?
|
I dont think I am doing at the correct place then. Because I did that step in the serial console located in my solusvm container.
Also, I think I have to do this "which vzctl" on the host like you said. Which I don't think I have the access to the host you mentioned. But I tried doing that in serial console, it returns nothing.
What I owned is a VPS account from a hosting company. Not too sure a VPS account holder can do those?