HowtoForge Forums | HowtoForge - Linux Howtos and Tutorials

HowtoForge Forums | HowtoForge - Linux Howtos and Tutorials (
-   Installation/Configuration (
-   -   New Install on Wheezy (

drapsag 5th May 2013 19:10

New Install on Wheezy
I just created a standalone test server with Wheezy (Debian7) and ISPConfig and everything works except for the System Service Status.

Every service is shown Offline even though everything works properly and I can create new sites, new databases, DNS records, etc. and it all works.

I used the Debian6 perfect setup which might have been a mistake, but everything works except for the Show Service status.

This is probably something stupid I missed, but I can't figure it out. I read some other posts about Ipv6 but those fixes don't work.

Everything else in the Server State area shows up correctly (RAID State, Disk Usage, Server Load, Update State etc.) but the Show Services shows everything Offline.

This is a test server, so it's no big deal and I can reinstall from scratch, but I'd really rather not waste the time if the fix is easy.


beyerservice 5th May 2013 21:11

well i updates my squeeze to wheezy and after some changes to dovecot (i did have ip6 used and therefore it does not update until i add

listen= *
to dovecot.conf) i got everything working. service status also showing as running...

All times are GMT +2. The time now is 08:09.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.