HowtoForge Forums | HowtoForge - Linux Howtos and Tutorials

HowtoForge Forums | HowtoForge - Linux Howtos and Tutorials (http://www.howtoforge.com/forums/index.php)
-   Installation/Configuration (http://www.howtoforge.com/forums/forumdisplay.php?f=4)
-   -   How to Configure SNMP? (http://www.howtoforge.com/forums/showthread.php?t=45832)

dvd.debian 14th May 2010 19:04

How to Configure SNMP?
 
Dear all,
I am very new to SNMP
.
Even though the question may seem to be silly,
I want your help!!!

My Questions are:

1.I am using BOSS linux 3.1(A Debian Derived Linux).
what is the use of SNMP?

2.If we want to monitor a system, is it required
to have SNMP to be installed ?

3.How to install SNMP and configure it?

4.How to find the version of SNMP installed in my system?

I tried to find with snmpwalk - It showed version like

SNMP V2- MIB

and executed tcpdump and it showed results like

ICMP request on

SNMP Version 1


Actually what is the version?

If we planned to use SNMPV3, what should be done???

5.How to enable SNMP port?

I was using Hyperic HQ open source monitoring tool which was installed on
System A.
I wished to monitor System B and I specified the IP address of System B to monitor in the Webbased tool in System A.
When I clicked Ok button , i got a message like,

SNMP configuration is wrong . it asked SNMP IP ,SNMP port(161) and some thing like idescrie etc,

I am sure that the SNMP tool is running in the System B, but still
i am getting error messages like "Wrong Configuration'
What to do....?
I have been struck up for 2 days..
Please some one help....


All times are GMT +2. The time now is 21:13.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.