HowtoForge Forums | HowtoForge - Linux Howtos and Tutorials

HowtoForge Forums | HowtoForge - Linux Howtos and Tutorials (http://www.howtoforge.com/forums/index.php)
-   Kernel Questions (http://www.howtoforge.com/forums/forumdisplay.php?f=6)
-   -   Delay calculation calibrate.c (http://www.howtoforge.com/forums/showthread.php?t=44765)

vtapas 9th April 2010 21:39

Delay calculation calibrate.c
 
Well its a very simple problem I am not clear with some C syntax I am reading C and other books and I hope I shall be able to figure it out any ways but if some one feels I should be clear of some thing let me know I am not clear with the working of calibrate.c

I will quote the important lines of code that I think are confusing me and explain the aspects of them that I think I don't understand.


Code:

loops_per_jiffy = (1 << 12); /* Initial approximation = 4096 */
The choice of number 4096
power of 2 that is 12 why is that choosen.

Secondly
http://lxr.linux.no/#linux+v2.6.33/init/calibrate.c#L54
In comments it is mentioning

So, we do
* 1. pre_start <- When we are sure that jiffy switch hasn't happened
* 2. check jiffy switch
* 3. start <- timer value before or after jiffy switch
* 4. post_start <- When we are sure that jiffy switch has happened
What is all that pre_start and why is it needed to be used over here?

Here is some thing which I am wondering not because of logic in same program
while (ticks == jiffies);/* Wait till the start of next jiffy */

Till the start of next jiffy what is the processor busy with or how is the delay introduced here?Not the mathematical calculation for udelay or ndelay.
May be I am not clear with what I should search for.


All times are GMT +2. The time now is 08:53.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.