HowtoForge Forums | HowtoForge - Linux Howtos and Tutorials

HowtoForge Forums | HowtoForge - Linux Howtos and Tutorials (
-   HOWTO-Related Questions (
-   -   Replace Hard Drive (

dpn48312 29th December 2005 01:48

Replace Hard Drive
What steps do I follow to replace an older hard drive with a newer one so that my installation and configurations are saved, and the new drive is bootable?

I currently have SuSE 9.3 installed.

Thank you.

fraginhell 29th December 2005 02:02

If your just replacing one disk for another, e.g same space you could use dd.
dd will copy the disk block by block including the boot sector (boot loader) etc.
Simply install new harddrive into the exsisting system.
use dd to copy the entire disk.
Assuming you want to replace a disk of the same size this would be the least hassle and on the same machine. If your changing disks to increase space then this is just one option or to clone a disk to put in a another machine.
I can't help you with what the device names are on suse (I use FC (redhat)) myself but dd if=(input disk) of=(new disk) bs=512.
Remember you need the entire disk not just the partition.
Also do it from single user mode and ensure you havw fsck'd all your filessystems as you will copy over any problems otherwise.
Hope that helps a bit.


falko 29th December 2005 12:17

I think SystemImager is what you need. Read about it here:

All times are GMT +2. The time now is 18:06.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.