ISPConfig 2.2.8 + Dynamic IP + CENTOS 4.4

[error]

how to configure dynamic ip in ispconfig ??

Centos 4.4 and ispconfig 2.2.8

mi actual ip dynamic is 200.73.77.192 / http://200.73.77.192:81

thx!:D

[falko]

What's the output of ifconfig?

[error]

[root@servidor ~]# ifconfig

eth0 Link encap:Ethernet HWaddr 00:15:58:03:54:A9
inet addr:192.168.1.165 Bdcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80:21558ff:fe03:54a9/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:4247 errors:0 dropped:0 overruns:0 frame:0
TX packets:2913 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:3237440 (3.0 MiB) TX bytes:764243 (746.3 KiB)
Interrupt:169 Base address:0xfc00

eth0:0 Link encap:Ethernet HWaddr 00:15:58:03:54:A9
inet addr:192.168.1.101 Bdcast:192.168.1.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
Interrupt:169 Base address:0xfc00

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP BROADCAST RUNNING MTU:16436 Metric:1
RX packets:1117 errors:0 dropped:0 overruns:0 frame:0
TX packets:1117 errors:0 dropped:0 overruns:0 carrier:0
Collisions:0 txqueuelen:0
RX bytes:65329 (63.7 KiB) Tx bytes:65329 (63.7 KiB)

thx for response, sorry for me bad english!

[till]

You can not configure dynamic IP addresses in ISPConfig. Get a domain at e.g. dyndns.org and use ddclient to update the dns records for this domain automatically. Inside ISPConfig you must use your internal IP address 192.168.1.165 or 192.168.1.101 depending on your router settings.