PDA

View Full Version : suggestions Wireless net

rickygm
22nd May 2006, 17:48
hello forum, I have a Wireless router Linksys SRX200 and I want to mount a wireless network with having Authenticated , my router is supported to create a secure wireless network and authenticated?
falko
23rd May 2006, 00:21
What exactly is your problem? :confused:
rickygm
23rd May 2006, 08:13
I don't still begin to configure my wireless network, what I want to know is that if I can mount a wireless network authenticated with the Linksys SRX200 + CentOS 4.2?

if I have problems in the road, I will publish them

thank you experts and linux users
falko
23rd May 2006, 10:34
What do you mean with "mounting a wireless network"?
rickygm
23rd May 2006, 16:25
you excuse me Falko , my English it is not very good, what I mean is that if I can create an authenticated wireless network with linksys SRX200+CentOS 4.2+Freeradius
falko
25th May 2006, 16:16
Maybe you can do it with OpenWRT: http://openwrt.org/
There are also some other projects that replace the original Linksys firmware and give you a whole bunch of possibilities... :)
socrazy143
28th May 2006, 06:20
It depends on how big of a network you plan on having. First and foremost I am not aware of a third-party firmware for your model number. If you want to mess with the firmware you are better off going to Buy.com and picking up a Linksys WRT54GL. Not the L. The version 5 WRT54G routers do NOT use Linux and therefore are useless with OpenWRT, Sveasoft and DD-WRT. There are other models besides Linksys to use as well.

Alas, if you are stuck with the SRX you might want to give a canned solution a shot rather than build it yourself. m0n0wall (http://www.m0n0.ch/wall) is one of the easiest but I am not sure what type of authentication it uses if any. It might just be a captive portal and if a CP is all you are looking for you can't beat the Sputnik firmware (http://www.sputnik.com) upgrade. It is easy to setup but again you will have to get a different router.

If you have some patience and skills you can setup NoCat (http://www.nocat.net). Rob Flickenger, author of Building Community Wireless Networks, co-wrote this software. It doesn't take a whole lot to setup but newbs might be wise to play in third-party firmware land.

There are a lot of choices out there but all take a little patience and lost of reading.