How to assign ip to virtual machine on cent os xen host machine?

[JACOBKELL]

I used this tutorial:
http://www.howtoforge.com/paravirtualization-with-xen-on-centos-5.3-x86_64
to install xen,but when i tried dhcp or manualy enter ip during installation of guest cent os machine,i get message no such site which i think probably means ip address which i entered didn't been accepted and it cannot connect to internet.Do i maybe first need to remove desired ip adress from host machine or is there something else to configure?

[falko]

The IP you want to use must not be configured anywhere else, e.g. on the host.
Do you have a DHCP server in your network?

[JACOBKELL]

The IP you want to use must not be configured anywhere else, e.g. on the host.
Do you have a DHCP server in your network?
I host on softlayer resseler,so i guess yes.I just ordered block of new ip's(4 new ip's)which i didn't added yet on host machine.Should i try now simply to add one of those new ip adress to guest machine?

[falko]

Yes, try that.

[JACOBKELL]

Nop still cannot find.
I find this about virtual machines on softlayer:
http://knowledgelayer.softlayer.com/questions/372/Static+and+Portable+IP+blocks
Maybe i need to assign entire block of ip to virtual machine?
And this is what i added now:
|IPv4 address: freeipadress___ / 255.255.255.0___ |
|Gateway: ____________________________ |
|Name Server: 10.0.80.11,10.0.80.12
I going to install iso from disk,so i can at least have prepared virtual machine.But it seems even then it is required
to define source of iso,what to select,cdrom,hard disk,nsf,http or ftp?

[JACOBKELL]

I found tutorial on softlayer(my host)for installing xen server and it seems it required a lot of network configuration edit.Can i send it to you so you can see it?There are some things which i don't understood there.

[matey]

they way I did it was to mount the xen FS onto /mnt/ then chroot to it then set name, root password and edit /etc/network/interfaces and do
auto eth0
iface eth0 inet static
address 10.0.52.110
netmask 255.255.255.0
network 10.0.52.0
broadcast 10.0.52.255
gateway 10.0.52.1

or something like that. then exit, umount then edit my xen config file /etc/xen/ and make sure I give it a virtual NIC
there are couple of ways that I know of, one is to use vif and the other to give it a MAC address then IP.

The thing I also do is when I chroot to /mnt/xenmachine/
I set root password the Same as the main machine's root just in case.
then you can change once boot up.