Hi, I followed the howto, I was able to successfully start the domu1 virtual machine but I ran into problems.

First, networking doesnt work :( I can see eth0 but it has no ip address.

Second, when I type df -h I dont see /dev/hda1. Is that normal?

I tried Falko howto (with image file), networking was working and I could see the "partition" doing df -h but I would prefer to write directly on a partition instead of an image file. Did some quick benchmark with his method, drive performance using an image file was around 50% of the native drive performance which is quite bad....

 Also is there anything special I need to put in the domain config file with a dual cpu machine? I have dual (2x)  xeon 5140 processor (dual core) with HT enabled. How many VCPU i have available? 4, 8?

thanks for your help!

Marc